BlueCast X5 LCD/DLP

BlueCast X5 per LCD/DLP

Fondibile: SI – Livello Fondibilità: Estrema

Compatible with: all LCD printers like Wanaho D7, Anycubic 3d, Zortrax, Phrozen, Prusa, X-Cube, Xayav V etc. (405 nm with 30 watt led or higher power)

Modalità di lavaggio: Alcol rosa / IPA 30 secondi _ Asciugatura con aria compressa

Cura UV: Non necessaria

Ritiro: Minimo

Colore: Azzurro

Primercat: Consigliato

Quantità: 500 gr

BlueCast X5 has been designed in order to help jewelers in realizing difficult models where dimensional accuracy and structural qualities are required. X5 is raw material based on a synthetized oligomer produced by BlueCast, for which patent is going to be applied. Thank to this resin, it is possible reach outstanding direct casting quality with any type of investment. X5 fits all jewelry needs from filigree to medals as well dental ones. Printed parts are strong enough to be handled without post-cure process, allowing for a faster, simpler workflow.

Main features:

  • Excellent casting of small engravings both positive and negative
  • Fast and detailed
  • No expansion during burnout, sublimation starts at 130 Celsius
  • Burnout will not release aggressive chemicals to investment (80% of burnout is composed by carbon dioxide and water and oxygen that is used to complete combustion)
  • No need of post-curing

DOWNLOAD : FEATURES    MSDS

– Custom syntetized oligomer by BlueCast, not available to market, patent is going to be applied.

– Excellent casting of small engravings both positive and negative

– Fits all jewelry needs from filigree to medals as well dental one

– Excellent for stones presetting

– Curing triggering tuned to maximize antialias smoothing

– No monomer inside, no smell

– No aggression on plastic parts (tested on PS, PMMA)

– No postcuring needed for casting

– No shrinkage

– Easy welding with wax, forget about pattern lost into investment

– Can be polished, engraved, drilled (postcure is needed)

– Low viscosity, easier to recover uncured resin from models, easy to wash

– No preheating required

– Very little hygroscopic while liquid, no water absorption while printed

– Atoxic, solvent free, very low phospine content, very low skin irritant

– Cleaner burnout, 0,00% ash residual

– Suitable for fast burnout

– Full burnout also at lower temperature (750 C°)

– No expansion during burnout, sublimation starts at 130 Celsius

– Excellent dimensional stability in time, no need to stock in cold/dark places